Progress Report #1: New calorimeter design will test nanocrack parameters

2

I’m starting a relatively rare kind of project for this field. I have designed and built a Seebeck type calorimeter for the purpose of testing my theory.

PROGRESS-REPORT.pdf

First, an attempt will be made to achieve reproducible heat production by applying my theory to the treatment of palladium-based samples. The treatment will be designed to create nano-sized cracks in which I propose the LENR process takes place. Once an active sample is obtained, it will be studied as the cathode in an electrolytic cell placed in a calorimeter.

A variety of behaviors will be explored including loading behavior, emission of photon radiation, effect of temperature on energy production, and the effect of laser light. The cathode can be rotated with respect to the GM detector and the laser to determine whether the angle of emitted or applied radiation relative to the surface is important.

View inside the calorimeter showing the components. The cell is in the center, the GM detector is on the left, and the fan is on the right.
View inside the calorimeter showing the components. The cell is in the center, the GM detector is on the left, and the fan is on the right.

Based on my theory, I predict that all occasions when LENR is observed, the same mechanism is operating. Therefore, information obtained using PdD would apply to all other materials and isotopes of hydrogen found to produce the same phenomenon.

The electrolytic method is chosen for this study because it is the most explored and best understood of the various methods known to initiate LENR. Nevertheless, the calorimeter would permit use of any other methods for initiating the effect, but on a small scale. The size of the sample is not important as long as accuracy of the measurement is sufficient large. The calorimeter used here is designed to have very high accuracy, which will be demonstrated in due course.

The following predictions will be explored:

1. The rate of the LENR reaction is regulated by the availability of hydrogen to the NAE, with a significant rate being possible at low hydrogen isotope compositions when the amount of NAE is sufficiently large.

2. The rate of the LENR reaction is affected by temperature only as result of how it effects the diffusion rate of hydrogen through the material.

3. Photon radiation will be emitted when LENR occurs, with a particular relationship between the angle between the surface and the detector.

4. The rate of the LENR reaction already underway can be increased by application of laser light, with an increased reaction rate as the energy of the light is increased. An enhanced effect can be expected when the frequency matches the dimension of an active crack.

5. Generation of excess energy does not require extended electrolysis when the NAE is created in advance.

This report describes the construction and physical layout of the calorimeter:

PROGRESS-REPORT.pdf

Top view of calorimeter assembly
Top view of calorimeter assembly

The next report will describe the calibration and the general behavior of the tool, followed by studies of various behaviors of PdD.

See also:

Progress Report #5

Progress Report #4

Progress Report #3

Progress Report #2

Progress Report #1

2 thoughts on “Progress Report #1: New calorimeter design will test nanocrack parameters

  1. Wouldn’t copper be better. Less thermal capacity. Better heat conductor. Less impact on neutron activation. Denser thus better sheilding against ionizing radiation.

Leave a Reply to Edmund Storms Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.